| |
Container candle making machine
Container Shape , This kind machine is suitable for the Round or
Square Container shape. 1. A brief of the candle making machine
My moulding machines are specially designed for making candles of
various forms.
2. Structure and Performance of common candle making machine
2.1 Structure
The machine is composed of candle holding dish, water tank, machine
frame, spool box, hand wheel, spindle, bevel gear, lead screw, nut,
nut shelf, bearing box, cross beam, push-off tube and candle
moulding tubes, etc. 2.2 Performance
2.2.1 Water tank, candle moulding tube enable the fluid wax to
solidify by means of circulating water in the tube.
2.2.2 Candle holding dish make usre that the wick is in the center
of the tube and the candle to be properly placed and clamped.
2.2.3 Lead heads and push-off tubes are used for the forming of the
candle tip and the push of the candle from the candle moulding
tube.
2.2.4 The spool box is used for mounting the wick spool. 3. Installation and Test run
The machine is a movable design and need no fixed foundation just
place the machine smooth and steady.
Check carefully if any spare parts are turning loose or tends to
fall off, and clean the accumulated dirt on all parts of the
machine. Fill oil on all lubrication points. Candle moulding tubes
shall be smeared with small amount of lubricant or white Vaseline
oil. Raise and lower the cross beam of the unloaded machine several
times, if it's very flexible to be started and in normal operation,
then do the followings:
3.1 If there is clearance between the lead head and the candle
mould cavity, expanding the punch can be used to strike the lead
head lightly, so that the fitting between the lead head and the
candle mould will be closed sealed to prevent any leakage of wax
liquid. 3.2 Threading with candle wick. When threading with candle wick on
a candle moulding machine of 240 piece capacity, attention shall be
paid to the treading method. Since there are 8 rows of candle
moulding tubes on water tank, and there are 10 rows of spool in the
spool will be too far from the hole on the cover of the spool box,
and this may result in a mess of the threading. Therefore, grouping
method must be adopted. Threading starts from both ends and
advances to the middle part, only by this means can threading be
prevent from getting into a mess.
3.3 Swing the crank handle to lower the cross beam to the stopping
position. 4. Operation Process
4.1 Rotate the hand wheel to making cross beam fall to the lower
stopping position. Place the candle holding-dish in the slot on the
locating plate, pull the locating plate to the front stopping
point. Hang the wick in the serrate slot of the candle-holding
plate. When the wax liquid half solids, cut off the wick, remove
the candle-holding, dump the residual wax liquid. When the wax
liquid in the candle moulding tube completely solidifies, rotate
the hand wheel, through movement of the bevel gear, lead screw, nut
and nut shelf, move the cross rail and push the candle off tube.
Put on the candle-holding dish to store the candle. Let the wick
enter the serrated hole, rotate the hand wheel to lower the cross
beam to the lower stopping position. 5. Packing and transportation
The machine shall be covered with a plastic film to prevent
entrance of water. It shall be enclosed by wooden box combined with
iron nails. The box shall be reinforced by iron wires at the two
ends to prevent damages in transportation. The box shall not be
turned upside-down and shall avoid clashes.
| |
